Go to shopping and design shop Design and shop


Go to startpage shop@nithrone


Foam wrap application instructions

Put contact adhesie on both the seatfoam and the closed cell EVA foam sheet. Let it dry for 5 to 10 minutes untill touchdry.

Turn the seat over and line it up in the middle of the EVA foam sheet. With one hand push the foam from front to back on the seatfoam.

Turn the seat over and make sure there is no bubbles and looks like this from the top.

Now work the EVA foam sheet from side to side untill it wraps around the edges.

Apply some contact adhesive on the plastic base and on the overhanging EVA foamwrap. Wait till touchdry.

Fold the overhang onto the plastic base so its completly covered around all sides.

Trim all excess foamwrap off with a cutting knife so there is about 1 to 2 cm wrap. Pull the cuttings off by hand.

Ready to put your new seatcover on.....

See how...go here!